Ready To Use Liquid Stencil Remover

Ready-to-use stencil liquid remover for fast and thorough removal of direct emulsions, CDF Direct-Films, and Pulsar indirect film from all types of mesh including metalized polyester.

Will not etch mesh; contains no strong alkalis or hypochlorites. Ideal for use in tanks: will not attack adhesives on stretch and glue frames; tank heating unnecessary. Odor free

INSTRUCTIONS
  1. Remove ink with the proper solvent.
  2. Use Screen Degreaser Liquid No. 3 to remove solvent residues and to help speed the action of the stencil remover. Rinse thoroughly.
  3. Use a soft brush to apply Stencil Remover Liquid No. 4 on the screen from both sides.
  4. Wait five minutes - no longer. Do not allow the stencil remover to dry on the screen, as this can result in a permanent stencil.
  5. Wash away the stencil with a hard spray of water, preferably a power spray.
  6. Tank method: Dilute Stencil Remover No. 4 with water (no more than 1:2) - but only after thorough testing. It is recommended, however, that Ulano No. 4 be used at full strength for fastest and most thorough stencil removal.

Stencil Remover Liquid No. 4 is a strong oxidant. It can cause skin irritation; use gloves. Keep the container closed tightly. Clean spills immediately. 
First Aid: In case of contact with the eyes or skin, flush immediately with water. If irritation develops, contact a physician.

AVAILABILITY
  • QSRL4 1 quart (0.946 liters) 12 per case
  • GSRL4 1 gallon (3.785 liters) 4 per case
  • 5GSRL4 5 gallons (18.927 liters)
  • 50GSRL4 50 gallons (189.25 liters)

Tech Data Sheet (English)