Ready To Use Stencil Remover Paste

Ready-to-use paste for fast and thorough removal of direct emulsions, CDF Direct Films, and Pulsar indirect film from all types of mesh including metalized polyester.

INSTRUCTIONS
  1. Remove ink with the proper solvent.

  2. Degrease first with Screen Degreaser Liquid  No. 3 to remove solvent residues and to help speed the action of the stencil remover. Rinse thoroughly.

  3. Use a soft brush to apply Stencil Remover Paste No. 5 on the mesh from both sides.

  4. Wait five minutes - no longer. Do not allow the stencil remover to dry on the screen, as this can result in a permanent stencil.

  5. Wash away the stencil with a hard spray of water, preferably a power spray.

  6. Note: Avoid freezing Stencil Remover Paste No. 5. Freezing and thawing will change the consistency from a paste to a liquid. This has no effect on the chemical activity as a stencil remover - it can be used in the same way as Stencil Remover Liquid No. 4.

Stencil Remover Paste No. 5 is a strong oxidant. It can cause skin irritation; use gloves. Keep the container closed tightly. Clean spills immediately. 
First Aid: In case of contact with the eyes or skin, flush immediately with water. If irritation develops, contact a physician.

AVAILABILITY
  • GSRP5 1 gallon (3.785 liters) 4 per carton

  • 5GSRP5 5 gallons (18.927 liters)

  • 50GSRP5 50 gallons (189.25 liters)

Product Fact Sheet (English)

Tech Data Sheet (English)

Tech Data Sheet (Spanish)